System 74 14 599 R/L
=> €/$

DIY cdi ignition kit for 4 cylinder 4 stroke car distributer (no V-engines, only in-line engines)

solid state high output condenser discharge ignition (CDI) to be installed in stock distributer housing for 4 cylinder 4 strokes car engines. 2 twin gnition coils, converter and advance unit have to find a place elsewhere near the engine outside distributer

this is a do DIY kit, customer has to physically adapt the hall element (mostly by adding some adapter piece) to the stock distributer housing and to fit the hall rotor to the distributer shaft (modification on internal diiameter of hallrotor)

click pictures to enlarge them

• material is new and available
• solid state, con tactless ignition on hall effect basis with automatic advance control
• no problem any more with points and  govenor

• this material does not simply replace the points by a hall element leaving the stock govenor, stock ignition coil and distributer finger in place
• if offers a genuine CDI with nearly 40KV output and not only a transistor trigger for the stock coil.
• it is not based on a photo sensor which easily malfunction in conditions of of oil and dirt and it does not have any open printed circuit boards which corrode as you have in some other offers.
• it may be run on 6 or 12V batteries

• assembly instructions
• parts in the pack (Photo)
• technical wiring
• dimensions of 1 exit ignition coil
• dimensions of twin ignition coil
• dimensions converter
• dimensions advance unit

• ignition system for Simca 8 (System 74 13 599)
• (modified) VW distributer
• converter and advance, an example installation

• modified distributer on engine
• ready distributer
• further distributer
• the hall sensor element
• the hall rotor
• example for adapter
• example installation in car